Technical: March 2012 Archives


My final /etc/networking/interfaces file looks like (this is for Debian)

auto lo eth0 tap0 br0

iface lo inet loopback

iface br0 inet dhcp
bridge_ports eth0 tap0
bridge_maxwait 0

iface eth0 inet manual

iface tap0 inet manual
pre-up tunctl -b -u <my_user_name> -t tap0
pre-up ifconfig tap0 up
post-down tunctl -d tap0

I stole this from the following site joost.damad.be

Beware the username enttry above needs to be changed to your username... You will also need to install uml-utilities. Once I had this running I could start my image as follows:

qemu -net nic -net tap,ifname=tap0,script=no -hda debian.img
Add to delicious Digg This Add to My Yahoo! Add to Google Add to StumbleUpon
| | Comments (0) | TrackBacks (0)

I encountered this error while trying to mount an image created using qemu. The command from the docs says to run the following command to mount it on the loopback device.


mount -o loop,offset=32256 debian.img ./mntpoint

This is completely wrong because the data start is not 32kb into the image file. To figure out where it starts you need to use the following commands:

]$ fdisk -ul debian.img

you must set cylinders.
You can do this from the extra functions menu.

Disk debian.img: 0 MB, 0 bytes
255 heads, 63 sectors/track, 0 cylinders, total 0 sectors
Units = sectors of 1 * 512 = 512 bytes
Sector size (logical/physical): 512 bytes / 512 bytes
I/O size (minimum/optimal): 512 bytes / 512 bytes
Disk identifier: 0x00077ccb

     Device Boot      Start         End      Blocks   Id  System
debian.img1   *        2048     5785599     2891776   83  Linux
Partition 1 does not end on cylinder boundary.
debian.img2         5787646     6141951      177153    5  Extended
Partition 2 does not end on cylinder boundary.
debian.img5         5787648     6141951      177152   82  Linux swap / Solaris

Once you have this output you can see that the data starts at sector 2048 and since sector size is 512 on my image I need to set the offset to 512*2048. So the final working command is:

mount -o loop,offset=$((512*2048)) -t ext3 ./debian.img ./mntpoint


and we now have a mounted image file.
Add to delicious Digg This Add to My Yahoo! Add to Google Add to StumbleUpon
| | Comments (0) | TrackBacks (0)